Daily Use - Hoover HDIH 2T1045 User Manual

Daily use

Start a Program
1. Open the door and Press the ON/OFF button
2. Press to select the program you want on the dishwasher control panel.
3. Press and close the door to start the program．
NOTICE
If the MEMO MODE YES The appliance remembers the last program
you used. The next time the appliance will switch on, the appliance pre-selects
the program last used.
Pause and restart a wash program
1. Open the door carefuly to pause the program. The digital scrolling display
PAUSE and the pause beep will sound while the dishwasher is paused.
NOTICE
There is a risk of being sprayed with hot water,do not fully open the door until
the spray arms have stopped rotating.
2.Load, remove, or rearrange any dishes if needed.
3.Close the door to restart the program.
Cancel or change a wash program
Open the door carefully to pause the program. Press and hold
Washing program reset. And then you can choice a new wash program to start.
Start a Program with Delay
Set a start time by the following procedure in order to delay a program start:
1.Set a program.
2.Press and hold the reservation button
3.Press the START/PAUSE button
The display shows the countdown of the start delay. The countdown decreases
with steps of 1 minute.
When the countdown is completed, the program starts.
18
to turn the dishwasher on.
.
and close the door.
3 sec,