WEG Drive Scan Manual page 50

SETTING THE DRIVE SCAN ON THE MFM
Step 17 The Drive Scan is already properly configured on the MFM
Configure the Eth1 Ethernet network interface
Use DHCP: enable/disable the use of DHCP;
Default Route: enable/disable the use of default network route for the destination address of
the IP packets;
IP Address: Ethernet interface IP address;
Network Mask: network mask related to the IP address of the Ethernet interface;
Gateway: Gateway network IP address;
DNS 1: First DNS server IP;
DNS 2: Second DNS server IP.
Configure the RS-485 serial network interface
Speed: baudrate;
Bits: number of communication bits;
Parity: communication parity:
–
–
6
–
Stop bits: number of communication stop bits.
Click on "Save Configuration"
Wait for the Drive Scan to restart, and it will be ready to be operated
Medium Voltage Devices | 6-12
none,
even,
odd
(Figure
Figure 6.20: Drive Scan linked to the MFM
Figure 6.21: Ethernet network configuration
(Figure
(Figure 6.21).
(Figure 6.22).
6.22).
6.20).
(Figure 6.20).