Setting The Drive Scan On The Mfm - WEG Drive Scan Manual

6 SETTING THE DRIVE SCAN ON THE MFM

Before starting to make the Drive Scan settings, it is necessary to register all assets that will be monitored through
the Drive Scan on the WEG Motion Fleet Management platform
The Drive Scan can be connected to the internet and MFM platform by setting and using the Drive Scan Wi-Fi
antenna or by connecting a network cable to the GbE0 ethernet port.
For the Drive Scan configuration, follow the instructions below:
Step 1 Connect an Ethernet cable between the computer and the Drive Scan GbE0 port (located next
to the power supply connector), as shown in
Step 2 Open a web browser on your computer.
Enter the default IP, 192.168.0.10, into the address bar, as shown in
Press the <Enter> key.
SETTING THE DRIVE SCAN ON THE MFM
(Chapter
Figure 6.1.
Figure 6.1: Preparing for the Drive Scan configuration
Figure 6.2: Connecting to the Drive Scan
3).
Figure 6.2.
Medium Voltage Devices | 6-1
6