WEG Drive Scan Manual page 32

CONNECTING A DEVICE TO THE DRIVE SCAN
in Figure 5.16. The converter is compatible with any MVW3000 firmware version. All manuals and softwares are
available to download on WEG download center (www.weg.net).
5
Figure 5.16: Ethernet/Serial WEG RS485-ETH-N converter
After the Gateway Master installation, start it.
To begin the setup an USB cable is necessary to connect the converter with the computer. Then, it is necessary to
choose the device to be configured (Etor, in this case). The Etor converter is the first item on the left of the window
(Figure 5.17).
Figure 5.17: Selecting the device to setup in Gateway Master
In the next step, it's necessary to select the connector type used to make the configurations. In this case, it's the
USB cable (Figure 5.18).
Medium Voltage Devices | 5-13