Table of Contents
Advertisement
Power over Ethernet (PoE)
The IP camera is PoE- compliant, allowing transmission of power
and data via a single Ethernet cable connected to PoE switch.
Accessing Reset Pin and SD card slot
If you forget the IP address or login credentials of camera then the
camera can be reset to factory default settings using the reset pin.
To access the Reset pin
1. Open the Sunshield by removing the sunshield screw.
Figure 6
Sunshield
15
Sunshield
Screw
2. Open the front cover by rotating it in the anti-clockwise
direction.
Figure 7
Front cover
3. Press the Reset switch for minimum 5 sec and release the
switch to reset the camera to default settings.
Figure 8
Reset Pin
16
Advertisement
Table of Contents
