Accessing Reset Switch & SD Card Slot
If you forget the IP address or login credentials of camera then the
camera can be reset to factory default settings using the reset switch.
Ÿ
The Reset switch is located as shown in Figure 12. Press the Reset
switch for minimum 5 sec and release the switch to reset the
camera to default settings.
Ÿ
You can insert the SD card in the slot to store your camera
recordings, see Figure 11.
Figure 11
Reset Switch
Figure:12
15
SD Card Slot
IP66 Protection Accessory Installation
1. By default your camera contains the LAN connector fitted by IP66
protection accessory.
Power cable
IP66 protection accessory
2. The IP66 protection assembly consist of tail end, middle part,
"IO" ring and LAN connector as shown below.
Tail end
3. Rotate the middle part of IP66 assembly in anticlockwise direction
to detach the IP66 accessory from the LAN connector.
Middle
"O"ring LAN
Part
Connector
16