Table of Contents
Advertisement
Installation
Before you start
Please make sure,
Ÿ
The device in the package is in good condition and all the
assembly parts are included.
Ÿ
All the related equipments are powered-off before installation.
Ÿ
The wall or ceiling is strong enough to support the weight of
camera.
Step 1: Select a Location
Select a suitable location for your camera to enable coverage of the
intended surveillance area. The location should preferably be a flat
surface, such as a wall or a ceiling.
You can install the camera where cables are running through the
interior of the wall or ceiling as shown in Figure 2. Else cabling has to
be done through POE.
Step 2: Prepare for Installation
Ensure that the necessary cabling to connect the camera to LAN
port and Power outlet are in place. The connecting cables from the
monitoring site should be ready at the installation site.
You can insert SD card in camera to store recordings during
network failover and to upload image or clip as a result of event
trigger.
See page 15 to know how to open the camera and insert the SD
card.
7
Step 3: IP66 Protection Accessory Installation
1. By default your camera contains the LAN connector fitted by IP66
protection accessory.
Power cable
IP66 protection accessory
2. The IP66 protection assembly consist of tail end, middle part,
"IO" ring and LAN connector as shown below.
Tail end
3. Rotate the middle part of IP66 assembly in anticlockwise direction
to detach the IP66 accessory from the LAN connector.
Middle
"O"ring LAN
Part
Connector
8
Advertisement
Table of Contents
