Table of Contents
Advertisement
Step 4: Installing Mounting Template
•
Stick the Mounting Template on the desired installation surface.
•
Drill three holes through the markings of the Mounting Template
on Wall or Ceiling.
•
Insert the screw grips in the holes you drilled.
Ceiling Mounting: Figure 2
Mounting Template
11
Wall Mounting: Figure 3
Step 5: Mounting the Camera
•
To avoid cable damage, take the Power, Ethernet, Audio IN,
Audio OUT, Alarm IN, Alarm OUT cables of the camera through
the cable guide on the base plate, see Figure 3.
•
Align the screw holes on the base plate with those you drilled on
the installation surface.
•
If the cabling is running through the interior of the wall or ceiling
behind the installation surface then, drill the hole (20mm approx)
on the center of the mounting template through the false ceiling.
Before you mount the base plate, pull the cables of the camera
through the hole drilled on the installation surface, see Figure 2.
•
Secure the base plate of the camera on the installation surface
with the supplied screws.
Step 6: Adjusting the Camera Angle
•
Use the Allen Key supplied to you to loosen the socket screws
on the pivot joint between the base plate and the camera body.
•
Tilt the camera body to achieve the desired angle. You can turn
the camera upto 360 degrees.
•
Hold it at the desired angle and tighten the socket screw with the
Allen key.
12
Advertisement
Table of Contents
