Table of Contents
Advertisement
Installation
Before you start
Please make sure,
•
The device in the package is in good condition and all the
assembly parts are included.
•
All the related equipments are powered-off before installation.
•
The wall or Ceiling is strong enough to support the weight of
camera.
Step 1: Select a Location
Select a suitable location for your camera to enable coverage of the
intended surveillance area. The location should preferably be a flat
surface, such as a wall or a Ceiling.
Step 2: Prepare for Installation
•
The camera can be powered-up by an adaptor or PoE switch. In
case, the camera is to be powered up by adaptor, a 5A plug is
needed nearby.
•
Provide proper connectivity between camera and recording
location through LAN cable.
•
It is advisable to make concealed wiring. However, wiring can
also be done externally.
You can insert SD card in camera to store recordings during network
failover and to upload image or clip as a result of event trigger.
See page 15 to know how to open the camera and insert the SD
card.
7
Step 3: Installing Mounting Template
•
Stick the Mounting Template at the exact location of camera
installation. The location can be ceiling or wall.
•
Drill three holes through the markings provided on the Mounting
Template on Wall or Ceiling.
•
Insert the screw grips in the holes you drilled, see Figure 2.
•
In case of concealed wiring, a separate hole has to be drilled in the
center for cable outlet.
Figure 2
Wall/Ceiling
Mounting
Template
8
Advertisement
Table of Contents
