Advertisement
CAUTION:
maximum weights indicated. Use with equipment heavier than the
maximum indicated may result in instability causing possible injury.
B-Tech AV Mounts, it's distributors and dealers are not responsible for damage or injury caused by improper installation,
improper use, modifications, installations over the specified weight capacity and/or failure to observe these safety
instructions. In such cases, any warranty will expire.
It is recommended that this product should only be installed by a qualified professional / installer.
B-Tech AV Mounts does not claim any liability for any difficulties that may arise from the interpretation contained
in these instructions. Failure to mount this product correctly may lead to serious injury and/or death.
Please check carefully to make sure there are no missing or defective parts - defective parts must never be used.
In the event of missing and/or defective parts, or technical questions, please contact an authorised dealer.
Pay careful attention to where this product is located, some locations are not suitable for installation. For indoor use only.
It is recommended that periodic inspections of the product are made as frequently as possible to ensure that safety is maintained.
Please keep these instructions for future reference.
1.
INSERT COLLARS TO TOP OF COLUMN
Insert both items C1 into the rear slots of the column (Note: Ensure nuts slide into the slots).
Set item C1 50mm apart and from the top of the column.
1
COLUMN
REAR SLOT
2.
FIX END CAP TO COLUMN
Attach item 3 to the top of the column using the M6 x 12mm
screws supplied with the column (BT8385-190).
Note: Insert
Rail Mounting
Plate (BT8385-RTC)
to Column
(BT8385-190) before
attaching End Cap.
INSTALLATION SAFETY INSTRUCTIONS
This product is intended for use only with the
Installation Instructions
4
REAR SLOT
Ensure nuts slide into slots
BT8385-RTC
BT8385-190
2
1
See back page on how to combine columns
TOP
COLUMN
1
1
M6 x 12mm
SCREW
3
COLUMN
Advertisement
