Handling The Machine's Interior - Ricoh Ri 2000 Quick Installation Manual

• If a metal object, water or some other fluid gets inside the machine, you must turn off its power
immediately. After turning off the power, be sure to unplug the machine. Then contact your service
representative and report the problem. Do not use the machine. Doing so may result in fire or electric
shock.
Do not touch this machine if a lightning strike occurs in the immediate vicinity. Doing so may result in
•
electric shock.
• The machine weights around 140 kg (308 lb.).
• Six or more people are required to lift the printer. When moving the printer, lift it slowly so that you do
not strain yourself. Lifting the printer forcibly or handling it roughly to drop it will risk injury.
Unplug the machine before you move it. While moving the machine, take care that the power cord does
•
not get caught under the machine. Failing to take these precautions may result in fire or electric shock.
When lifting and lowering the front cover, be sure to hold the part shown below. Be careful so that
•
your hand or any other part of your body is not caught with the front cover.

Handling the machine's interior

Do not remove any covers or screws other than those explicitly mentioned in User Manual.
•
Before you remove the cover, turn off the power switch on rear of the machine. Removing the cover
•
with the power on or removing parts other than those explicitly referred to may result in electric shock.
• Do not attempt to disassemble or modify this machine. Doing so risks burns and electric shock.
Do not lift the cover while the machine is operating. Doing so may cause your hand or fingers to get
•
trapped in the machine, and an injury may occur.
9