Summary of Contents for Wren Kitchens Vogue WALL UNIT 700 Tall 2 Door
Page 1
WALL UNIT 700 - 800 Tall 2 Door Assembly Guide 700 Tall 800 Tall For Internal Use: FI.WR.INS.046.WKIN00131_WALL_700-800_2DR_TALL.Rev6...
Page 2
WALL UNIT 700 - 800 Tall 2 Door Assembly Guide BEFORE YOU START INSTALLATION SHOULD BE PERFORMED BY A COMPETENT PERSON ONLY. THIS PRODUCT COULD BE DANGEROUS IF INCORRECTLY INSTALLED Panel A Panel B Panel C Loose Shelf Frontal x1 Back Panel x2 End Panel x2 Base Panel (packed separately)
Page 3
Step 1. Seat dowel (F) into holes in Step 2. end panel (B) as Seat (G) Seat cam dowel (G) cam dowel shown. into holes in into hole as shown. end panel (B) as shown. Step 3. Attach panels x2 (C) to panel (B), using cam dowels (G) (in blue) and also using dowels (F) (in orange) in...
Page 4
WALL UNIT 700 - 800 Tall 2 Door Assembly Guide Step 6. Seat dowel (F) into holes in both panels (B) as Seat (G) Cam Dowel Step 7. shown. into hole as Seat cam dowel (G) shown. into holes in both end panels (B) as shown.
Page 5
Step 10. Ensure unit is square. From Top 94mm 126mm Step 11. Slide the back panel clips (T) into the groove of both panels (B) & (C)s. The back panel clips (T) should be evenly spaced as shown and positioned to allow the hanging bracket and corner gussets to be fitted.
Page 6
WALL UNIT 700 - 800 Tall 2 Door Assembly Guide Care to be taken. Hanging procedure is necessary for a safe installation. Step 13. Hanging Brackets steps a,b & c to be carried out on both sides as shown Detail A Detail A Detail A Step a...
Page 7
Screws for attaching to walls are not provided as these vary depending on materials, thickness and construction. Ensure appropriate fixings for wall construction are used. Step 16. Measure appropriately and attach the 2 x hanging bracket Hanging Bracket plates onto the wall screwing Plate through the provided holes into your wall.
Page 8
WALL UNIT 700 - 800 Tall 2 Door Assembly Guide Step 19. Insert hinge in top & bottom holes as shown below. Step 20. Secure hinges by tightening 2 x screws with hinge dowels attached. These are already positioned within the hinges. Step 21.