Table of Contents
Advertisement
RCM Series User Manual
Internal Serial Interface Configuration
The KVM over IP switch provides a function that lets you configure an
attached device's serial interface parameters from within any accessed server.
To do so:
1. From the accessed server, open a command line (terminal) session or third
party serial application such as HypterTerminal or PuTTY.
2. Telnet or SSH to the KVM over IP switch's IP address.
3. Log in with your usual Username and Password to bring up the access
screen:
Navigation
The left panel shows the KVM over IP switch at the top, and all the serial
interface devices connected to it listed below. The right panel shows the
configuration parameters at the top, with the configuration settings in the area
below.
Use the Left and Right Arrow keys (
between the right and left panels, and to select the parameter to configure.
Use the Up and Down Arrow Keys (
and the serial devices in the left panel; use them to select the configuration
items in the right panel.
268
←
→
and
) to move the highlight bar
↑
↓
and
) to select among the switch
Advertisement
Table of Contents
