Function And Control; Introduction Of Control Panel - Gree GJC12AG-E6RNB3A Service Manual

Service Manual

6.Function and Control

After putting through the power, air conditioner will give out a sound and indicators on control panel will be on. After that, you operate the
air conditioner through remote controller or control panel.

6.1 Introduction of Control Panel

Note:If wireless remote controller is lost, open the surface panel and operate manually.
1.POWER BUTTON
Operation starts when pressing this button, and stops when pressing this button again.
2.SWING BUTTON
Activate the automatic air swing function.
3.FAN SPEED BUTTON
Select the fan speed HIGH, MID, LOW and AUTO in sequence.
4.TEMP/TIMER BUTTON
① Press the▲keypad to increase the set (operating) temperature of the unit.and Press the▼keypad to decrease the set (operating)
temperature of the unit.The temperature seting range is from 16~30℃ .
② Press the▲keypad also to increase the selected time in 0.5h(1h) hour increments,and Press the▼keypad to decrease the selected
time in 0.5h(1h) hour decrements,Timer setting range is 0.5~24 hours.
Note:When operating the unit with control panel:when the timer range is 0~10h, the timer scale is 0.5h; when the timer range is 10~24h,
the timer scale is 1h. When operating the unit with remote controller, the timer scale is 0.5h.
③ Under on status, timer function can let the complete unit operate at COOL mode for a while and then switch to fan mode. The fan
mode is AUTO fan speed.
5.SIGNAL RECEIVER
6.MODE BUTTON
Select the operation mode, AUTO, HEAT, COOL, FAN,DRY (for reverse cycle model) or COOL,FAN, DRY(for cooling only model).
7.FILTER BUTTON
This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient operation and cooling. The LED (light) will
illuminate after 250 hours of operation. To reset after cleaning the filter, press the"Check Filter" button and the light will go off.
9
Technical Information