Table of Contents
Advertisement
Service Manual
6. Function and Control
6.1 Introduction of control panel
Dual-8 nixie tube
Cool mode indicator
+ / - button
Dry mode indicator
Fan speed indicator
Fan mode indicator
Sleep button
Timer button
Mode button
ON/OFF button
Fan button
Operation of control panel
Note:
●After putting through the power, the air conditioner will give out a sound. After that, you can operate the air conditioner by the
control panel.
● Under ON status, after each pressing of the button on control panel, the air conditioner will give out a sound. Meanwhile,
corresponding indicator on control panel will be bright.
● Under OFF status, dual-8 nixie tube on control panel won't display.
Under ON status, dual-8 nixie tube on control panel will display set temperature under cooling mode, while it won't display under
other modes.
1. ON/OFF button
Press this button to turn on or turn off air conditioner.
2. + / - button
Under cooling mode, press "+" or "-" button to increase or decrease set temperature by1°C(°F). Set temperature range is
16°C(61°F)~30°C(86°F). Under auto, drying or fan mode, this button is invalid.
3. Mode button
Press this button and the mode will circulate according to below sequence:
→
COOL
DRY
FAN
COOL: Under this mode, cooling mode indicator is bright. Dual-8 nixie tube displays set temperature. Temperature setting range
is16°C~30°C.
DRY: Under this mode, drying mode indicator is bright. Dual-8 nixie tube won't display.
FAN: Under this mode, air conditioner operates at set fan speed. Fan indicator and corresponding speed indicator is ON. Dual-8
nixie tube won't display.(Note: You must connect the heat-discharge pipe before operating cooling or drying mode. No need for only
fan mode.)
4. FAN button
Press this button and the fan speed will circulate as "low speed→medium speed →high speed→auto fan→low speed".
5. Timer button
Press timer button to enter into timer setting mode. Under this mode, press " + " or " - " button to adjust the timer setting. Timer
setting will increase or decrease 0.5 hour by pressing " + " or " - " button within 10 hours, while timer setting will increase or decrease
1 hour by pressing " + " or " - " button beyond 10 hours.After timer setting is finished, the unit will display temperature if there's no
operation for 5s. If timer function is started up, the upper indicator will keep the display status. Others, it won't be displayed. Under
timer mode, press timer button again to cancel timer mode.
6. Sleep
Press sleep button to enter into sleep mode. If the controller operates at cooling mode, after sleep mode is started up, preset
temperature will increase by 1°C within 1 hour ;preset temperature will increase by 2°C within 2 hours and then the unit will operate
at this temperature all the time; Sleep function is not available for fan mode, drying mode and auto mode. If sleep function is started
up, the upper indicator will keep the display status. Others, it won't be displayed.
18
Advertisement
Table of Contents
