Ford 1997 Aerostar Manual page 226

Removing jumper cables
1. Always remove the jumper cables in the
reverse order. Remove the negative ( ) end
of the jumper cable from the metallic surface
on the engine or frame of the disabled
vehicle.
2. Remove the negative ( ) cable from the
booster battery.
3. Remove the positive (+) cable from the
booster battery.
4. Remove the other end of the positive (+)
cable from the discharged battery.
After the vehicle is started, let it idle for a while
to let the engine "relearn" its idle conditions.
Drive it around for a while with all electrical
accessories turned off to let the battery recharge.
Driveability may be deteriorated slightly until all
drive modes are "relearned." You may need to
use a battery charger to fully recharge the
battery.
If you need to replace your battery, see Battery
in the Maintenance and Care chapter.
Towing Your Vehicle
The recommended method to tow your Aerostar
is with flatbed or wheel lift equipment.
However, slingbelt towing is acceptable. On
vehicles equipped with an under-vehicle spare
tire carrier, remove the tire assembly from the
carrier and store it in a secure area before
towing. For E-4WD vehicles, the 4-wheel drive
system must be disabled prior to towing. The
transmission must be in N (Neutral) and the
ignition switch must be in the OFF position to
disable the Electronic 4-Wheel Drive System.
226