Ford 1997 Aerostar Manual page 121

3. Pull the belt out of its holder as far as it will
go and untwist the belt or remove the object
that is jamming the belt. Let the belt retract.
4. Then, pull the belt out and let it retract
several times to make sure that the belt
works properly.
For Twisted Rear Outboard Combination
Lap and Shoulder Safety Belts —
Detachable Anchor
Disengage the detachable anchor tongue from
the detachable anchor, remove the twist and
re-install the detachable anchor tongue end into
the detachable anchor until you hear a snap and
feel the latch engage.
Procedure to Correct a Twisted Safety Belt
at the "D" Ring (if so equipped) Front
and/or Rear Outboard Seating Positions
NOTE: The restraint system shown in the
following figures may be different than
the restraint system in your vehicle.
However, use these figures and this
procedure to correct a twisted safety
belt at any outboard seating position
that has a "D" ring.
119