Related Manuals for ADLINK Technology TRL-40
Summary of Contents for ADLINK Technology TRL-40
- Page 1 TRL-40 ® ® E-ATX Dual Intel Xeon E5 Series 4U Industrial Server User’s Manual Manual Rev.: 2.02 Revision Date: Dec. 30, 2016 Part No: 50-1X009-1020 Advance Technologies; Automate the World.
- Page 2 Revision History Revision Release Date Description of Change(s) 2.00 2014/5/9 Initial release 2.01 2014/8/15 Revised Spec 2.02 2016/12/30 Revised spec, updated content...
- Page 3 TRL-40 Preface Copyright 2016 ADLINK Technology, Inc. This document contains proprietary information protected by copy- right. All rights are reserved. No part of this manual may be repro- duced by any mechanical, electronic, or other means in any form without prior written permission of the manufacturer.
- Page 4 Conventions Take note of the following conventions used throughout this manual to make sure that users perform certain tasks and instructions properly. Additional information, aids, and tips that help users perform tasks. NOTE: NOTE: Information to prevent minor physical injury, component dam- age, data loss, and/or program corruption when trying to com- plete a task.
-
Page 5: Table Of Contents
TRL-40 Table of Contents Preface ..................iii List of Figures ............... vii List of Tables................ix 1 Introduction ................ 1 Overview................1 Features................2 Specifications............... 3 Block Diagram ..............6 Functional Description ............6 Mechanical Drawings............7 Rear I/O Connectors............10 Board Layout .............. - Page 6 This page intentionally left blank. Table of Contents...
-
Page 7: List Of Figures
Figure 1-1: TRL-40 Block Diagram ............ 6 Figure 1-2: TRL-40 Front View............7 Figure 1-3: TRL-40 Rear View ............8 Figure 1-4: TRL-40 Right Side View ..........8 Figure 1-5: TRL-40 Left Side View............. 9 Figure 1-6: TRL-40 Top View............. 9 Figure 1-7: TRL-40 Underside View.......... - Page 8 This page intentionally left blank. viii List of Figures...
-
Page 9: List Of Tables
TRL-40 List of Tables Table 1-1: General Specifications............. 5 Table 1-2: Rear I/O Panel Legend ..........11 Table 1-3: TRL-40 Board Layout Legend ........14 List of Tables... - Page 10 This page intentionally left blank. This page intentionally left blank. List of Tables...
-
Page 11: Introduction
PCI Express x16 slots, one PCI Express x8 slot, one PCI Express x4 slot, dual PCI Express-based Gigabit Ethernet, six SATA 6 Gb/ s ports and two SATA 3Gb/s ports make the TRL-40 ideal for vision and automation control, medical, test & measurement, and telecom applications requiring a high-performance, easy-to-deploy and reliable server. -
Page 12: Features
1.2 Features 430 W x 176 H x 567 D mm (16.9 x 6.9 x 22.3")(w/o handles) ® ® Supports dual Intel Xeon Processor E5-2600 series in LGA2011 package Dual channel DDR3 1600 MHz memory for each CPU, up to a maximum of 128 GB in eight DIMM slots ... -
Page 13: Specifications
TRL-40 1.3 Specifications Processor/System ® ™ Intel Xeon E5-2658, 2.1GHz, QPI 8GT/s, 20MB Cache, 32nm, 95W TDP, LGA2011(8C) ® ™ Intel Xeon E5-2648L, 1.8GHz, QPI 8GT/s, 20MB Cache, 32nm, 70W TDP, LGA2011(8C) ® ™ Intel Xeon E5-2620, 2.0GHz, QPI 7.2GT/s, 15MB Cache, 32nm, 95W TDP, LGA2011(6C) ®... - Page 14 Power Supply 600W PS/2 single power supply Single 100-240VAC, 9-4A, 47-63Hz 4x Serial ATA ports with 6 Gb/s data transfer rate from Marvell 88SE9230 (SATA port from Marvell support RAID 0/1/10) 2x Serial ATA ports with 6 Gb/s data transfer rate from Serial ATA 2x Serial ATA ports with 3 Gb/s data transfer rate from (SATA port from PCH support RAID 0/1/5/10)
- Page 15 TRL-40 Storage -20˚C to 80˚C Temperature Table 1-1: General Specifications Model naming convention is as follows: TRL-40-AABBCCDEFFGHHH NOTE: NOTE: Where: AA:CPU BB:RAM CC:HDD D:ODD E: Power supply FF:OS G: Accessory HHH:Reserved(000) Example:TRL-40-22080210001000 22:-Intel Xeon E5-2658 v2, 2.4GHz, QPI 8GT/s, 25MB Cache,...
-
Page 16: Block Diagram
1.5 Functional Description Processor Support ® The TRL-40 is a dual processor design based on the Intel® Xeon Processor E5-2600 family. One LGA-2011 socket connects to an Intel C604 chipset through a 5 GHz Direct Media Interface (DMI). The system clock generator is set by the processor delivering 100MHz host clock. -
Page 17: Mechanical Drawings
Eight lanes of PCI Express Gen2 ports are supported. Dual-Channel DDR3 Memory The TRL-40 supports dual channel DDR3 1600 MT/s ECC regis- tered or non-ECC unbuffered DIMMs up to 128GB total system memory in eight DIMM slots. Gigabit Ethernet ®... -
Page 18: Figure 1-3: Trl-40 Rear View
10.3 101.6 Figure 1-3: TRL-40 Rear View 92.1 92.1 92.1 52.7 10#-32 16.4 Figure 1-4: TRL-40 Right Side View Introduction... -
Page 19: Figure 1-5: Trl-40 Left Side View
TRL-40 Figure 1-5: TRL-40 Left Side View Figure 1-6: TRL-40 Top View Introduction... -
Page 20: Rear I/O Connectors
Figure 1-7: TRL-40 Underside View The TRL-40 must be protected from static discharge and physi- cal shock. Never remove any of the socketed parts except at a static-free workstation. Use the anti-static bag shipped with the WARNING: product to handle the board. Wear a grounded wrist strap when installing and/or servicing. - Page 21 TRL-40 RS-232/422/485 4x USB 2.0 NIC0 NIC1 Table 1-2: Rear I/O Panel Legend Serial Port Connector (COM1) Pin # RS-232 RS422 RS485 DCD, Data Carrier Detect TXD- Data- RXD, Receive Data TXD+ Data+ TXD, Transmit Data RXD+ DTR, Data Terminal Ready...
- Page 22 LAN Port (NIC0/1, RJ-45) Refer to the tables below for the LAN port pin and LED definitions. 10BASE-T/ Pin # 1000BASE-T 100BASE-TX BI_DA+ BI_DA- LED1 LED2 BI_DB+ BI_DC+ BI_DC- BI_DB- BI_DD+ BI_DD- LAN Status LED1 (left) LED2(right) Network link is not established or system power off 10 Mbps Blinking...
-
Page 23: Board Layout
TRL-40 1.8 Board Layout Figure 1-9: TRL-40 Board Layout Introduction... - Page 24 JP6/JP7 COM1 Mode Selection Jumper P12VPWR1 EPS 12V Power Connector (8-pin) P12VPWR2 ATX12V Power Connector (4-pin) PCIE_SLOT1~6 PCI Express Slots RAID_SATA1~4 SATA Connector (RAID support) SATA1~4 SATA Connector SYS _FAN1~4 System Fan Connector Table 1-3: TRL-40 Board Layout Legend Introduction...
-
Page 25: Onboard Connectors
TRL-40 1.9 Onboard Connectors Serial Port Connector - RS-232 (COM2) Pin # Signal Function Data Carrier Detect Data Set Ready Receive Data Request to Send Transmit Data Clear to Send Data Terminal Ready Ring Indicate Ground CPU/System Fan Connectors (CPU_FAN#/SYS_FAN#) - Page 26 HD Audio Daughter Board Connector (H_AUDIO1) This connector is designed for use with the ADLINK DB-Audio2 daughter board. Pin # Signal Function Ground AUD_BCLK Audio Clock Ground ICH_AUD_SDIN1 Audio Data Input + 5V ICH_AUD_SDOUT Audio Data Output P5V_AUD + 5V P3V3_DVDD 3.3V AUD_SYNC...
-
Page 27: Jumpers & Switches
TRL-40 SATA Connectors Pin # Signal USB 2.0 Pin Headers (H_USB1~2) Pin # Signal Pin # Signal USB0- USB1- USB0+ USB1+ 1.10 Jumpers & Switches Clear RTC (CLR_RTC1) Clear BIOS settings and data/time. CMOS Status Connection Normal 1 – 2 Clear RTC 2 –... - Page 28 Clear CMOS (JP1) Clear the BIOS settings. CMOS Status Connection Normal 1 – 2 Clear CMOS 2 – 3 Marvell SATA RAID Test Mode (JP2) For debug use. Status Connection Normal 1 – 2 Enable 2 – 3 BMC Console Port (JP3) Pin # Signal VCC 3.3V...
- Page 29 TRL-40 SATA1 Function Selection (JP5) Disable to use PCIe Mini-Card in mSATA mode. Status Connection SATA (default) 1 – 2 Disabled 2 – 3 COM1 Mode Selection (JP6/JP7) Status RS-232 Short 2-3 Short 1-2 RS-422 Short 2-3 Short 2-3 RS-485...
- Page 30 This page intentionally left blank. Introduction...
-
Page 31: Getting Started
Driver CD Quick Start Guide 2.2 Driver Installation The following provides information on how to install the TRL-40 device drivers in Windows 7 64-bit. The device drivers are located in the following ADLINK All-in-One CD directories: Display X:\IMB-S90\Graphics... - Page 32 XXX (where XXX is Sandy Bridge or Ivy Bridge). Follow the instructions given and reboot when instructed. 4. Install the Ethernet driver by running the program Autorun.exe from X:\IMB- S90\LAN\513189_Release_17_4_OEM_Gene_284334 _split. Follow the instructions given and reboot if required. 5. Install the Marvel RAID driver by opening device man- ager.
-
Page 33: Important Safety Instructions
TRL-40 Important Safety Instructions For user safety, please read and follow all instructions, Warnings, Cautions, and Notes marked in this manual and on the associated device before handling/operating the device, to avoid injury or damage. S'il vous plaît prêter attention stricte à tous les avertissements et mises en garde figurant sur l'appareil , pour éviter des blessures... - Page 34 Never attempt to repair the device, which should only be serviced by qualified technical personnel using suitable tools A Lithium-type battery may be provided for uninterrupted backup or emergency power. Risk of explosion if battery is replaced with one of an incorrect type;...
- Page 35 TRL-40 BURN HAZARD Touching this surface could result in bodily injury. To reduce risk, allow the surface to cool before touching. RISQUE DE BRÛLURES Ne touchez pas cette surface, cela pourrait entraîner des blessures. Pour éviter tout danger, laissez la surface refroidir avant de la toucher.
- Page 36 This page intentionally left blank. Important Safety Instructions...
-
Page 37: Getting Service
San Jose, CA 95138, USA Tel: +1-408-360-0200 Toll Free: +1-800-966-5200 (USA only) Fax: +1-408-360-0222 Email: info@adlinktech.com ADLINK Technology (China) Co., Ltd. Address: (201203) 300 Fang Chun Rd., Zhangjiang Hi-Tech Park Pudong New Area, Shanghai, 201203 China Tel: +86-21-5132-8988 Fax: +86-21-5132-3588 Email: market@adlinktech.com... - Page 38 84 Genting Lane #07-02A, Cityneon Design Centre Singapore 349584 Tel: +65-6844-2261 Fax: +65-6844-2263 Email: singapore@adlinktech.com ADLINK Technology Singapore Pte. Ltd. (Indian Liaison Office) Address: #50-56, First Floor, Spearhead Towers Margosa Main Road (between 16th/17th Cross) Malleswaram, Bangalore - 560 055, India Tel: +91-80-65605817, +91-80-42246107 Fax:...
Need help?
Do you have a question about the TRL-40 and is the answer not in the manual?
Questions and answers