2.
SAFETY RULES.
2.1
General Considerations.
The manufacturer is deemed absolved of all liability in the following circumstances:
•
if the products is used improperly;
•
if the product has not been installed in accordance with the instructions in this
manual
•
if the product has been installed in an environment that does not comply with the
conditions set by the manufacturer
•
if the product has been altered by the customer in any way without the express
written authorisation of the manufacturer
•
If the user has not followed the instructions given in this manual
•
if the product has suffered the consequences of exceptional events such as floods,
earthquakes, etc. and has been put back into operation without the necessary
checks being made.
2.2
Safety in Use.
Once the products has been installed before starting work check:
for visible defects on the safety devices;
for correct operation of the device;
2.3
Safety in Maintenance.
Before carrying out any maintenance operation on the products it is mandatory:
Read this instruction manual;
Use the correct tools for the maintenance operations that have to be done;
Do not clean the electrical parts of the feeder with water or other fluid;
On completing the repair work, check that all the tools have been collected up
WARNING
•
Only qualified personnel are allowed to carry out maintenance work.
•
Maintenance staff must wear working clothes (with tight sleeves) and
individual protective equipment (gloves, safety glasses, etc.) in conformity
with safety legislation and binding safety standards.
•
Any alteration to the product or replacement of any parts made without the
manufacturer's authorisation may cause an accident hazard and absolves
the manufacturer from all civil and criminal liability.
•
If an emergency situation arises because of a fire, it is forbidden to use
water to put the fire out; always use powder-type extinguishers.
6 / 30
Cod.: PL-000603X-D002G