Table of Contents
Advertisement
6 Advanced Application
6.1 Setting 0 % and 100 % output
parameters
As for stepping operation and percentage display, 0% and 100% should be set before
using. Some gear values have been set when delivered from the factory and set values
are illustrated below:
Output function
Thermocouple J type
Thermocouple K type
Thermocouple T type
Thermocouple E type
Thermocouple R type
Thermocouple S type
Thermocouple B model
Thermocouple N model
The default set values may not meet your requirements, so which can be reset. Then
you can display the percentage with stepping or slope output as well as display the
percentage. Adjust the output value with keys
long time until the buzzer works to define the new 0% or 100% values. The new
defined span value is saved in the calibrator storage automatically and remains
effective after restart. The flowing operations are available with the setting:
Press
DC mV
or
for manual steeping (increase or decrease) output based
0% value
0.00 mV
0.0 ℃
0.0 ℃
0.0 ℃
0.0 ℃
0 ℃
0 ℃
600 ℃
0.0 ℃
, press
100% value
100.00 mV
1000.0 ℃
1000.0 ℃
400.0 ℃
800.0 ℃
1500 ℃
1500 ℃
1800 ℃
1000.0 ℃
or
13
for a
Advertisement
Table of Contents
