Table of Contents
Advertisement
3 Function Usage
3.1 DC V Measurement
The default function of the calibrator after start-up is voltage measurement. If it is
required, press
V).Please connect the lines after all functions are selected. The connection mode and
interface are shown in Figure 3.1-1:
3.2 DC mV Measurement
Press
to re-select the DC mV function (the display unit is mV), the connection
mode is same to voltage measurement.
3.3 DC mV Source
Press
and
that of voltage measurement. When the mill-volt is overload, there is sign of
to re-select the voltage measurement (the display unit is
Figure 3.1-1
to select the DC mV output , the connection mode is same to
,
9
Advertisement
Table of Contents
