Table of Contents
Advertisement
5
Simulating
(TC)
Connect calibrator input/output terminal to the instrument to be tested using
thermocouple. The connecting diagram is shown below, Proceed as follows to simulate
a thermocouple:
1.
Connect thermocouple to the TC input/output plughole of calibrator as shown in
Figure 5-1.
2.
If necessary, press
3.
Press
key to select thermocouple graduation.
4.
Press
or
to select
to select thermocouple function. If necessary, continue pressing the
to select temperature. Press
Thermocouples
mode.
or
Figure 5-1
to select digit.
12
Advertisement
Table of Contents
