Item
Memory type and size
NVRAM
Combo interfaces
HIMs
MIMs
Physical dimensions (H
× W × D)
Hardware encryption
Power consumption
Hot swapping
Memory modules must be used in pairs. Make sure they are of the same type and size.
For a Combo interface, the default operating interface is the electrical interface.
For a Combo interface, you can use either the electrical Ethernet interface or the optical
Ethernet interface. You can use the combo enable { copper | fiber } command in interface
view to switch between the optical and electrical interfaces.
For details about the combo enable { copper | fiber } command, refer to Ethernet Interfaces in
the Access Volume of HP SR6600 Routers User Manual.
Use optical transceivers provided by HP only. The device may be incompatible with other
optical transceivers and thus displays alarms automatically.
"Hot-swapping" a module refers to first using the remove slot slot-number command to stop
the module, and then manually pulling it out, or inserting the module into its slot without
powering off the device. For details about the remove slot command, refer to Device
Management in the System Volume of HP SR6600 Routers User Manual.
DDR2 SDRAM
1 GB (default, two 512 MB memory modules)
2 GB (maximum)
1.5 GB not supported
128 KB
2
electrical interfaces
(automatic MDI/MDI-X)
optical interfaces
2
2
45 × 399 × 412 mm (1.77 × 15.71 × 16.22 in.)
Supported
125W
Supported
Specifications
10 Mbps, half/full-duplex
100 Mbps, half/full-duplex
1000 Mbps, full-duplex
1000 Mbps, full-duplex