HP A6604 Installation Manual page 13

Memory type and size
NVRAM
Console port
AUX port
Management Ethernet interface
CF card
USB interfaces
Dimensions (H × W × D)
Power consumption
Reset button
Hot swapping
Flash is used for storing the boot file—the BootWare program.

The memory is used for storing the data during system operation and caching the data during

data forwarding.
The non-volatile random access memory (NVRAM) is used for storing the exception information

of the system during operation.
A CF card is used for storing programs and configuration files of the device.

Hot-swapping a module refers to first using the remove slot slot-number command to stop the

module, and then manually pulling it out, or inserting the module into its slot without powering
off the device. For details about the remove slot command, refer to Device Management in the
System Volume of HP SR6600 Routers User Manual.
LEDs
Figure 1-10 LEDs on the RPE-X1
(1) Run LED (RUN)
(3) Alarm LED (ALM)
(4) Ethernet link state/data reception & transmission LED (LINK/ACT)
(5) CF LED (CF)
Item
DDR2 SDRAM
1 GB (default, one memory module)
2 GB (maximum)
128 KB
1 (9600 bps to 115200 bps, 9600 bps by default)
1 (9600 bps to 115200 bps, 9600 bps by default)
1 (10Base-T/100Base-TX/1000Base-T)
256 MB by default for the built-in CF card
256 MB, 512 MB, or 1 GB for an optional external CF card (CF cards
less than 256 MB are not supported)
2 (USB 0: Type A connector, operating in the host mode; USB 1:
Type B connector, operating in the device mode)
40 × 199 × 282 mm (1.57 × 7.83 × 11.10 in.)
37 W
1
Supported
Specification
(2) Active LED of the RPE-X1 (ACT)
(6) USB interface 1 LED (USB)