HP A6604 Installation Manual page 67

Figure 4-18 Loosen the captive screws on the RSE-X1
Step4 Pull the two ejector levers at both ends of the RSE-X1 outward to release the RSE-X1, and
then gently pull the RSE-X1 out along the slide rails.
Figure 4-19 Pull out the RSE-X1
To protect the removed RSE-X1, place it in an antistatic bag.

If you do not install a new RSE-X1 in the slot, install a blank panel to prevent dust from entering

the chassis. For how to install a blank panel, refer to
on page 4-35.
Installing and Removing a FIP
Interior Structure of a FIP
The router configured with the RPE-X1 supports four types of FIPs: FIP-100, FIP-110, FIP-200,
and FIP-210.
The router configured with the RSE-X1 supports two types of FIPs: FIP-100 and FIP-200. The
FIP-100/FIP-110 supports MIMs only, while the FIP-200/FIP-210 supports MIMs, HIMs, and
HIM/MIM intermixing.
"Installing and Removing a Blank Panel"