Mitsubishi Electric A800-GF Instruction Manual page 91

Check and clear of the fault history
Fault history clearing procedure
POINT POINT
• Set Err.CL Fault history clear = "1" to clear the fault history.
Screen at power-ON
1.
The monitor display appears.
Parameter setting mode
2.
Press to choose the parameter setting mode. (The parameter number read previously appears.)
Selecting the parameter number
3.
Turn until
Fault history clear
Turn to change the set value to "
" " and "
4.
90
PROTECTIVE FUNCTIONS
Operation
(fault history clear) appears. Press
". Press
" flicker alternately after parameters are cleared.
•Turn to read another parameter.
•Press to show the setting again.
•Press twice to show the next parameter.
to read the present set value. "
to start clear.
" (initial value) appears.