Mitsubishi Electric A800-GF Instruction Manual page 17

Removal and reinstallation of the operation panel or the front covers
Removal of the upper front cover
(a)
(a) With the lower front cover removed, loosen the mounting screws on the upper front cover. (These screws cannot be removed.)
(b) While holding the areas around the installation hooks on the sides of the upper front cover, pull out the cover using its upper side
as a support.
(c) With the upper front cover removed, the control circuit can be wired and the plug-in option can be installed.
Reinstallation of the front cover
(a)
(a) Clip on the upper front cover as illustrated. Check that it is properly secured.
(b) Tighten the screws on the lower part of the upper front cover.
(c) Attach the lower front cover using the screws. The number of screws differs depending on the capacity of the inverter.
NOTE
• When installing the upper front cover, fit the connector of the operation panel securely along the guides of the PU connector.
• Fully make sure that the front cover has been reinstalled securely. Always tighten the installation screws of the front cover.
16
INSTALLATION AND WIRING
(b)
Loosen Loosen Loosen
(b)
(c)
(c)
Tighten Tighten Tighten
Tighten Tighten Tighten