Nonin 8500AV Operator's Manual page 4

Hand-held veterinary pulse oximeter
Table of Contents

Advertisement

The audible alarm of the Model 8500AV is for the convenience of the attendant near the patient. These units are
not intended to call an attendant from another room or from a distance. The user must determine the audible
distance based on the operating environment.
Alkaline batteries must not be inserted improperly, charged, or disposed of in fire. They might leak or explode.
This equipment complies with International Standard EN 60601-1-2:2001 for electromagnetic compatibility for
medical electrical equipment and/or systems. This standard is designed to provide reasonable protection against
harmful interference in a typical medical installation. However, because of the proliferation of radio-frequency
transmitting equipment and other sources of electrical noise in healthcare and other environments, it is possible
that high levels of such interference due to close proximity or strength of a source might disrupt the performance
of this device. Medical electrical equipment needs special precautions regarding EMC, and all equipment must be
installed and put into service according to the EMC information specified in this manual.
This device has not been tested for immunity to electromagnetic disturbances.
Portable and mobile RF communications equipment can affect medical electrical equipment.
Manufacturer's Declaration
Refer to the following table for specific information regarding this device's compliance to IEC Standard 60601-1-2.
Table 1: Electromagnetic Emissions
Emissions Test
Compliance
This device is intended for use in the electromagnetic environment specified below.
The customer and/or user of this device should ensure that it is used in such an environment.
RF Emissions
Group 1
CISPR 11
RF Emissions
Class B
CISPR 11
Harmonic
N/A
Emissions
IEC 61000-3-2
Voltage
N/A
Fluctuations/
Flicker Emissions
IEC 61000-3-3
Electromagnetic Environment— Guidance
This device uses RF energy only for its internal function.
Therefore, its RF emissions are very low and are not likely to cause
any interference in nearby electronic equipment.
This device is suitable for use in all establishments, including
domestic and those directly connected to the public low-voltage
power supply network that supplies buildings used for domestic
purposes.
2

Advertisement

Table of Contents
loading

Table of Contents