Table of Contents
Advertisement
1. Controller Board
2. Rear Cover
3. Power Connector
4. Paper Tray Cover
5. Intake Vent
6. SD Card Slots
7. Optional Interface
Board Slot
8. Ethernet Port
9. USB Port B
10. USB Port A
(Descriptions below
in the notes section)
1. Controller Board
Install internal options (SDRAM, HDD) directly on the controller board. Plug in cables,
SD cards, and optional interface boards via slots and plugs (see 6 through 10).
2. Rear Cover
Remove to replace the fusing unit.
3. Power Connector
Connect the power cord here.
4. Paper Tray Cover
Keeps paper in the tray free of dust.
5. Intake Vent
Inlets for cool air. Instruct the user not to obstruct the intake vents. (Doing so can
result in malfunctions caused by build up of heat inside the printer.)
6. SD Card Slots
Remove the cover to install SD cards here.
7. Optional Interface Board Slot
Insert an optional Wireless LAN interface unit, Gigabit Ethernet board, or 1284
interface board in this slot.
8. Ethernet Port
Use to connect the printer to a network.
9. USB Port B
Use to connect the printer to a computer.
10.USB Port A
Use to connect optional USB devices such as the authentication card reader.
Exterior Components 2
4
M080 Training - Sincere-P3
Advertisement
Table of Contents
