Table of Contents
Advertisement
Problems on the Road
~~~
~~~~
When you've turned the wrench almost
LS
far as it will go, swing it around to the
)ther side. Keep turning to raise the jack
ift head a few inches.
.
.I64
A
'osition the jack under the vehicle.
rhere are two locator triangles (A) on the
,anels (B) near each wheel. Raise the lift
lead (C) until it fits firmly under the steel
ocker flange (D) between the triangles
learest the flat tire.
f you have a ZR- 1 the triangles are on
he underside of the molding. The flange
s
inboard of the triangles.
I
Stay away from
the
moldings or fender
flanges to avoid damaging them.
NOTICE:
Raising your vehicle with the jack
improperly positioned will damage
the vehicle or may allow the vehicle
to fall off the jack. Be sure to fit the
jack lift head into the proper location
before raising your vehicle.
Raise the vehicle by turning the wheel
wrench clockwise. Raise the vehicle far
enough
off
the ground so there is enough
room for the spare tire to fit. Remove all
the wheel nuts and take off the flat tire.
Advertisement
Table of Contents
