To Install Your Convertible Hardtop - Chevrolet 1994 Corvette Owner's Manual

T O Install Your Convertible Hardtop
1. Park on a level surface, set the parkinl
brake firmly and shift an automatic
transmission into
"F'"
(Park). Shift
a manual transmission into
"R'
(Reverse). Lower both windows and
sunshades.
T u r n off the radio to lower
the power antenna and turn the
ignition key to "LOCK."
electrical connectors behind the lock
pillar.
3.
Lower the convertible top. Refer to
"Convertible Top" in the Index.
4. With one person on each side,
carefully position the hardtop over
the vehicle. Lower the hardtop slowly.
aligning the rear bolt spacers onto the
bezels, and front conical nuts into the
2. Disconnect both rear window defogger
tapered receivers. Realign the hardtop
if necessary.
NOTICE:
To help avoid damage, don't force
the rear of the hardtop down. The
hardtop may rest slightly above the
$forage compartment lid until the
release lever is pulled. See step 8 in
this procedure.
\ Q
\ \
i. Move both seatbacks forward. Slide
the lock pillar bracket into the receiver
bracket until the scribed line is even
with the lower edge of the receiver
bracket.
i. Connect the electrical connectors to
the hardtop rear window. Make sure
they are inside the vehicle.
7. Insert the two upper bolts (C), into
both receiver brackets. You
k a y
have
to lift the hardtop slightly to install the
lock pillar bracket.
8. If the hardtop hasn't lowered into
position, pull the release lever- behind
the driver's seat under the storage
compartment lid.
103
...