Table of Contents
Advertisement
This delay helps prevent a false reading.
If vehicle speed remains above 25 mph
(40 kmh) or the temperature goes down,
the display is updated immediately.
If your vehicle has been
off
for more than
three hours, the current outside
temperature will be stored in the system
when you start the vehicle.
Inside Temperature: This sensor is in the
center air outlet on the passenger side.
If you block or cover either interior
sensor, the system will give a false
reading.
Automatic Control
The system will adjust to maintain the
temperature you set. It will select the best
fan speed and air flow setting to keep you
comfortable with the least amount of
noise.
1. Press the arrows on the "TEMP SET"
switch to set a comfortable
temperature.
2. Press "AUTO."
The fan speed will adjust automatically
unless you press the arrows on the switch.
Manual Heating
The heater works best if you keep your
windows closed while using it.
1. Press the arrows on the "TEMP SET"
switch to set a comfortable
temperature.
2. Press
uj .
3.
Press the arrows on the fan speed
switch if you don't like the automatic
setting. In "AUTO
#
"
on cold days,
the fan will stay off until the coolant
warms up enough to heat your vehicle.
If your vehicle has an engine coolant
heater and you use it in cold weather,
0
O F
(-1 8
O
C) or lower, your heating
system can provide heat more quickly
because the engine coolant is already
warmed. See "Engine Coolant Heater"
in the Index.
Manual Bi-Level
Bi-level can heat or cool outside air and
direct it in two directions.
1. Press the arrows on the "TEMP SET"
switch to set a comfortable
temperature.
2. Press
3
.
3.
Press the arrows on the fan speed
switch if you don't like the automatic
setting.
Manual Ventilation
For mild outside temperatures, when little
heating or cooling is needed, you can still
direct outside air through your vehicle.
1. Press the arrows on the "TEMP SET"
switch to set a comfortable
temperature. For ventilation, the
system can't cool the vehicle below
the outside temperature.
2. Press d J
.
3.
Press the arrows on the fan speed
switch if you don't like the automatic
setting.
Manual Cooling
The air conditioner works best if you keep
your windows closed. On very hat days,
open the windows just long enough for
the hot air to escape.
1. Press the arrows on the "TEMP SET"
switch to set a comfortable
temperature.
2. Press
a.
After cool-down, adjust
the air flow to another setting. The
compressor works in all settings
109
...
Advertisement
Table of Contents
