Trouble Shooting; Recommendations; Description; Requirements - Haulotte HA26 RTJ O Maintenance Book

HA26 RTJ O - HA26 RTJ O SW - HA26 RTJ PRO - HA26 RTJ PRO SW -
HA80 RTJ O - HA80 RTJ PRO
E
- Trouble shooting and diagram
Trouble shooting and diagram

1 - Trouble shooting

1.1 - R
ECOMMENDATIONS
If a malfunction occurs, check the following points :
• There is sufficient fuel.
• Sufficient engine oil.
• Sufficient hydraulic oil in the tank.
• Batteries are charging.
• Control box E-stop push-buttons are pulled out.
• The control box selector key is set to platform or ground control box.
• Control box relays are engaged.
• Fuse status.
• Ground control box solenoid valve status.
If the malfunction persists, consult the troubleshooting table to identify the problem.
IF you cannot identify the problem, contact HAULOTTE Services®.
1.2 - D
ESCRIPTION
The FAILURES function describes the requirements relative to failures : monitoring, information
recording, information reading.
1.3 - R
EQUIREMENTS

Requirements

FAIL_xx_001 An ACTIVE failure ( A ) signals that the failure is stive active
A DETECTED failure ( D ) signals the cause of the failure has been valid one at least power on, but is
FAIL_xx_002
inactive
A code CODE is linked to failures which have several causes of activation to identify the one of activation (if
FAIL_xx_003
many conditions are active the code are added)
At power on, the failure log and failure counter are not changed for a failure which was already active at
FAIL_xx_004
power off
FAIL_xx_005 The failure log and failure counter are changed for a failure which internal code is changed
N.B.-:- VAR[A
4001055180
F ] = 1
CTIVE AILURE IF ONE OR MORE OF THE FOLLOWING FAILURES ARE IN ACTIVE STATE
E 06.21
Definition
USA / GB 397