Led Diagnostics & Troubleshooting - Xpresskit DBALL2 Installation Manual

Platform: DBALL2
Firmware: HK9 Remote Start Ready (RSR) Installation
LED Diagnostics & Troubleshooting
LED Status
Module Programming
Off
Off
Solid red
Solid
Flashes green &
Flashes red
green &
red
Flashes green
Flashes
green
continuously
Flashing orange
Flashes
orange
continuously
Solid green for 3
Solid
green
seconds
x3 sec
Solid orange for 3
Solid
orange
seconds
x3 sec
Module Programming - Error codes
Flashes
Flashes red x 1
red x1
Flashes
Flashes red x 2
red x2
Flashes
Flashes red x 4
red x3
External Module Synchronisation
Flashes red, red,
then orange x 10
Flashes
red, red,
orange
Active Ground While Running
Flashes
Flashes green
green
Flashes red &
orange
Flashes red
& orange
Flashes green
Flashes
green quickly
D2D and W2W Commands
Flashes orange x
Flashes
orange
1
x1
Flashes Flashes orange x
orange
2
x2
Flashes orange x
Flashes
orange
3
x3
RSR Code
Flashes
Flashes red x 7
red x 7
Description
Module has no power.
Module is powered. Waiting for
programming to begin.
Initialisation failed.
FTCAN and HSCAN detected.
FTCAN detected.
Module was successfully
programmed with transponder.
Module was successfully
programmed without transponder.
FTCAN not detected.
HSCAN not detected.
Bypass calculation failed.
OBDII feature not supported.
GROUND OUT ON (GWR)
command received.
IGNITION ON command received.
START ON command received.
LOCK command received.
UNLOCK command received.
TRUNK command received.
3x OEM Lock Remote Start
Activation was attempted when
RFTD feature is disabled.
Troubleshooting
Check the power connections.
Check if the ignition input is properly connected.
If a second attempt fails after a complete Hard Reset,
connect the module to Directechs.com and call Tech
Support with the module ID in hand.
Normal operation.
Normal operation.
Normal operation.
Normal operation.
Check the B-CAN wire connections. Wake up the data
bus by turning the ignition ON and try again.
Check the D-CAN wire connections. Wake up the data
bus by turning the ignition ON and try again.
Reset the module and try again. Make sure vehicle is
equipped with immobilizer. If so, make sure you have
the right EMS COM and that your connection is good.
Diagnostic data bus not detected. Some features are
not supported by SmartStart. This can be caused by
missing wire connections or module hardware limitation.
Refer to the wiring installation section to check the
connections.
Otherwise, the Ground While Running (status) signal
was lost or was never received by the module.
Commands can come from RF, D2D or W2W.
Otherwise, the ignition signal was not received by the
module. In a W2W install, it will show only if the ignition
input wire is used.
Otherwise, the start signal was not received by the
module. In a W2W install, it will show only if the ignition
input wire is used.
Normal operation.
Activated from Web automatically when using RSR
flash tool or can be done manually. Refer to feature
programing section for more information.
Rev.: 20160711
Page 8
© 2016 Directed. All rights reserved.