Led Diagnostics And Troubleshooting - Xpresskit XK09 SoleX Series Installation Manual

The Mobile Integration Systems
Platform: XK09
Firmware: CHRYSLER Remote Start Ready Installation
LED Diagnositics and Troubleshooting
LED Status
During Power Up
Flashes quickly
x1
secs
for 1 second
Solid
Flashes quickly
Flashes slowly Waiting for keyless.
Solid for 3
x3
secs
seconds
Flashes once
x1
quickly
Off
Remote Start Period
Solid
Off
Flashes for 1
x1
sec
second
Flashes
Programmed & Installed (Idle)
Off
Flashes for 1
x1
sec
second
Solid
Description
Module is in Standalone mode.
The bus type cannot be
detected.
The vehicle type is not yet
detected.
Module was successfully
programmed or is already
programmed.
Modules was reset.
Module has no power.
Incorrect behavior.
No Start command was received.
A command is processing.
The unit is in a remote start
sequence.
The unit is waiting for a
command.
A command is processing.
Incorrect behavior.
Troubleshooting
Normal operation.
Make sure the T-Harness is properly connected and
insert the key in the ignition switch.
Insert the key in the ignition switch and turn to the ON
position. You may need to wait up to 10 seconds.
Remove the key from the ignition switch and press
Unlock on the factory remote.
Normal operation.
Normal operation if the Programming button was held
during the power up sequence.
Check the power connections.
Data is not processing correctly. Disconnect the power
from the module and power up.
Make sure the module was programmed with the hood
open (Ground on Blue wire). If not, reset the module and
reprogram it with the hood open.
Normal operation upon receiving a command from the
remote.
Normal operation during runtime.
Normal operation.
Normal operation upon receiving a command from the
remote.
Data is not processing correctly. Disconnect the power
from the module and power up.
Rev.: 20120210
Page 16
© 2012 Directed. All rights reserved.