Connector Pin-Out; Cn1 Connecter - DAQ SB3-FRM13 K Series User Manual

3.3 Connector Pin-out

The board has several connectors and jumpers to set. The USB3-FRM13_K board is equipped
with two main connecters, USB3 B-type connector for USB connection and Camera Link
connecter for Base/Medium/Full Camera Link connection. The board has several Jumpers for
external I/O and Image acquisition.

3.3.1 CN1 Connecter

The USB3-FRM13_K has a USB-B type connector for high speed USB connection.
[Figure 3-2] and [Table 1] shows the CN1 connector and its pin description.
[Figure 3-2. CN1 Connecter (USB3.0 standard powered-B type Front View)]
[Table 3. USB3.0 Standard Powered-B Connecter]
Pin Signal Name
1 VBus
2 USB D-
3 USB D+
4 GND
5 StdA_SSTX-
6 StdA_SSTX+
7 GND_DRAIN
8
StdA_SSRX+
9 StdA_SSRX-
10 DPWR
11 DGND
9 8 7 6 5
2 1
USB B type
Connector
10
3 4
Description
+5V Power
USB2.0 data (Negative)
USB2.0 data (Positive)
Ground for Power Return
Super Speed Transmitter(Negative)
Super Speed Transmitter(Positive)
Ground for Signal Return
Super Speed Receiver(Positive)
Super Speed Receiver(Negative)
Power Provided by Device
Ground return for DPWR
17
- -
USB3-FRM13_K Users Manual (Rev 1.0)
11
http://www.daqsystem.com
Remark
+5V Power
USB2.0 Signal
USB2.0 Signal
USB Power GND
USB3.0 Signal
USB3.0 Signal
USB Power GND
USB3.0 Signal
USB3.0 Signal
USB Power GND
USB Power GND