Assembly And Adjustments - King Canada KC-5006R Instruction Manual

ASSEMBLING STAND
Assemble the stand using Fig.4 as reference. Loosely attach the legs (A)
Fig.4 on the outside of the top (B) and bottom braces (C) as shown using
carriage bolts (D) and hex. nuts (E). Place stand on a level surface and
tighten all hex. nuts.
Flip the stand upside down and install the 4 rubber feet (F) Fig.4 to the 4 legs
by pressing firmly. Flip the stand once again onto its feet.
MOUNTING TABLE SAW TO WORKBENCH
If you do not want to use the supplied stand and you prefer to mount the table
saw in a permanent location, it should be fastened securely to a firm
supporting surface such as a workbench, using the four mounting holes
supplied in the base. An opening MUST be made the same size as the
opening under the table saw base. This opening will prevent dust
accumulation inside the table saw base.
MOUNTING TABLE SAW TO STAND
Place table saw onto stand with base rubber feet installed (reduces
vibrations) and secure the table saw to stand using 4 hex. bolts (G) Fig.4,
washers (H) and hex. nuts (I).
MOUNTING HANDWHEEL HANDLE
The handle (A) Fig.5 must be mounted to the blade elevation/tilting handwheel
(B). Place nylon nut inside cavity behind the handwheel and secure handle
with screw (C) using a Phillips screwdriver.
RIVING KNIFE
Remove the table insert (A) Fig.6 from the table top by removing the small
screw (B) and then pulling it upwards. Turn the elevation handwheel (B) Fig.5
counterclockwise and raise the blade to its highest position above the table.
The riving knife (C) Fig.6 consists of a metal piece, slightly thinner than the
blade, that helps to keep the blade kerf open to prevent kickback. This saw is
shipped with the riving knife in the "down" position, as shown in Fig.6. The
riving knife must be positioned in the through-cutting or "up" position for all
other operations.
ASSEMBLY & ADJUSTMENTS
FIGURE 4
FIGURE 5
FIGURE 6