Related Manuals for King Canada KC-5007
Summary of Contents for King Canada KC-5007
-
Page 1: Instruction Manual
10” TABLE SAW INSTRUCTION MANUAL MODEL: KC-5007 COPYRIGHT © 2004 ALL RIGHTS RESERVED BY KING CANADA TOOLS INC. -
Page 2: Proof Of Purchase
Warranty does not apply to defects due directly or indirectly to misuse, abuse, negligence or accidents, repairs or alterations and lack of maintenance. KING CANADA shall in no event be liable for death, injuries to persons or property or for incidental, special or consequential damages arising from the use of our products. -
Page 3: General Safety Instructions For Power Tools
GENERAL SAFETY INSTRUCTIONS FOR POWER TOOLS 1. KNOW YOUR TOOL 12. ALWAYS WEAR SAFETY GLASSES. Read and understand the owners manual and labels affixed to Always wear safety glasses (ANSI Z87.1). Everyday the tool. Learn its application and limitations as well as its eyeglasses only have impact resistant lenses, thet are NOT specific potential hazards. -
Page 4: Electrical Information
ELECTRICAL INFORMATION WARNING! ALL ELECTRICAL CONNECTIONS MUST BE DONE BY A QUALIFIED ELECTRICIAN. FAILURE TO COMPLY MAY RESULT IN SERIOUS INJURY! ALL ADJUSTMENTS OR REPAIRS MUST BE DONE WITH THE TABLE SAW DISCONNECTED FROM THE POWER SOURCE. FAILURE TO COMPLY MAY RESULT IN SERIOUS INJURY! POWER SUPPLY WARNING: YOUR TABLE SAW MUST BE CONNECTED TO A 110V, 15-AMP. -
Page 5: Getting To Know Your Table Saw
GETTING TO KNOW YOUR TABLE SAW 14. BLADE GUARD 16. MITER GAUGE 2. TABLE 15. TABLE INSERT 10. MITER GAUGE SCALE 13. RIP FENCE 3. BASE 12. MITER GAUGE STORAGE 9. RIP FENCE POINTER (SIDE) 11. RIP FENCE STORAGE 1. POWER SWITCH 6. -
Page 6: Assembly And Adjustments
ASSEMBLY & ADJUSTMENTS MOUNTING TABLE SAW TO WORKBENCH If table saw is to be used in a permanent location, it should be fastened securely to a firm supporting surface such as a workbench, using the four mounting holes supplied in the base. 1. -
Page 7: Changing Blade
ASSEMBLY & ADJUSTMENTS MOUNTING AND ADJUSTING MITER GAUGE When cross cutting and the blade is set at 90 and 45 to the table, the miter gauge can be used in either slot on the table. When cross cutting and the blade is tilted, use slot on right side of table where the blade is tilted away from your hands and miter gauge. -
Page 8: Maintenance
1. Elevation, support rods, and gears. 2. Sliding rails and supports. 3. Table locking cams (Front & Rear). PARTS DIAGRAM & PARTS LISTS Refer to the Parts section of the King Canada web site for the most updated parts diagram and parts list.
Need help?
Do you have a question about the KC-5007 and is the answer not in the manual?
Questions and answers