Changing The Blade; Upper Blade Guide Assembly; Tilting The Table - King Canada KC-1401HD Instruction Manual

CHANGING THE BLADE

Removing the blade:
1. To change the blade, remove the four hand wheels on the front of the saw and
take the upper and lower covers off.
2. Remove the table insert from the center of the table, and pull out the table pin
from the side of the table.
3. Loosen the blade tension by turning the tensioning knob (A-Fig.13) counter-
clockwise.
4. Remove the plastic guard covering the left-hand side of the blade. Remove the
blade.
Replacing the blade:
When replacing the blade, make sure the blade is put on correctly, with the teeth
facing forward and pointing downward. To replace the blade, reverse the steps
in section "Removing the blade" but do not put the covers back on until the
blade is tensioned and tracking properly.
OPERATING INSTRUCTIONS
WARNING: Do not plug the saw into a power outlet or try to operate until the
saw is completely assembled, wired, all belts are aligned and tightened and the
blade is tensioned and tracking properly.

UPPER BLADE GUIDE ASSEMBLY

Before operating the saw, always adjust the blade guard so it just clears the piece
on which you are working. Not only is it safer, but it will hold the blade in
position for more accurate cuts. To adjust, loosen the hand wheel that is found
in the back and slide the rod and assembly into position.

TILTING THE TABLE

The table will tilt to make mitered and angled cuts. To tilt the table, loosen the
two hand wheels on the underside of the table, tilt the table to the desired angle
and retighten the hand wheels.
ADJUSTMENTS
FIGURE 13