Daq-202 Black Box Unit; Connecting Cables To Computer And Daq-202 Black Box Unit - Pentair INTELLIFLO Operation And Set Up Instructions

8
Connecting Cables to Computer and

DAQ-202 Black Box Unit

•
Monitor: Video/AC power cable
•
Speaker: Audio cable/USB power cable
•
Keyboard/Mouse: Wireless USB transmitter
•
DAQ-202 Unit: USB cable (already connected)
•
PC Computer: AC power cable
Connection Instructions
1. Connect the monitor power cord and video cable
to the monitor as shown.
2. Use speaker bar spring clamps to mount the
speaker bar to the bracket located on the
monitor stand shaft. (Note: the speaker volume
cannot be set up until the unit is started with the
computer running).
3. Route the monitor power cord, video cable, and
(2) speaker cables through the hole in the pump
board.
4. Plug the (2) speaker cables and video cable into
the PC computer (located on shelf in cabinet).
5. Route monitor power cord through the opening
behind computer shelf and plug into the AC
power strip.
6. Install batteries in both keyboard and mouse.
Refer to included instructions if needed. Plug
the keyboard/mouse USB transmitter into PC
computer.
7. Plug the PC computer power cord into AC power
strip.
Speaker USB
Power Cable
Black Box Unit
USB Cable
INTELLIFLO Variable Speed Pump Demo Kiosk Operation and Set Up Instructions
®
NOTE: Do not turn on the computer at this time.
Only connect the cables. Always follow the Start Up
Sequence found on page 10
1
Video Cable
2
Spring Clamps
Monitor Video
Keyboard/Mouse
Cable
USB Transmitter
3
Speaker Audio
Cable
PC Computer
Power Cable
Monitor
Power Cord