Purging Pressure Sensing Hoses; Software Updates; Using The Computer Program - Pentair INTELLIFLO Operation And Set Up Instructions

Purging the Pressure Sensing Hoses
(If pressure sensor box is installed)
1. Disconnect the high pressure (RED) tube to vent air
out of line (use lower pump speed while bleeding the
line).
2. Disconnect the low pressure (BLUE) tube, allowing
air to flow though tube until dry (about 15 seconds).

Software Updates

The computer shipped with this Kiosk Demo Unit has
pre-installed software. To be sure you have the most
updated software version, a flash drive with a software
update may be included. The software version is listed in
the bottom right corner of the program start up window.
Follow the instructions below to install the software
update, if applicable.
To avoid possible software conflicts, first uninstall
the existing version.
1. Click the 'Start' button (lower left corner of Windows
tool bar) and click 'Control Panel'.
2. Select 'Programs and Features'.
3. Select "Pentair Pump Data Acquisition System" and
click 'Uninstall' to unistall the previous version.
4. If applicable, uninstall the programs "FFDshow" and
"K-Lite Pack" if they show on the program list.
To install and run the updated the program software
1. Insert the flash drive into the laptop USB port.
2. Open the flash drive file from 'My Computer'.
3. Open file "DAQ Set Up (Version number)"
4. Follow the on-screen instructions to successfully
install and run the program.
5. Open the "Pentair Pump Data Acquisition System"
file to begin.
INTELLIFLO Variable Speed Pump Demo Kiosk Operation and Set Up Instructions
®
High Pressure
(Discharge)

Using the Computer Program

Click on the Pentair icon on monitor desktop to open
the "Pentair Pump Data Acquisition System"
program. Under normal operating circumstances, this
should start the Pentair Pump Data Acquisition System
(DAQ program).
If an error message appears, it's likely a communication
issue between the DAQ 202 Box and the PC. Check the
USB cable to be sure it's connected.
Comparative Cost Calculator
1. The Comparative Cost Calculator screen (shown in
image, right) will appear once the program is open.
2. Adjust the speed of the IntelliFlo pump from the
keypad, until the flow rate needle is within the green
"Optimum Pump Speed" zone, on the Flow Rate
meter.
This indicates the ideal flow rate for a 12 hour turn on
the selected pool size.
Comparative Cost Calculator screen shows the potential
energy savings when using an IntelliFlo
Pump vs. a Standard single speed pump.
11
Low Pressure
(Suction)
Variable Speed
®