Start Up And Operation; Water Fill And Priming; Start Up Sequence - Pentair INTELLIFLO Operation And Set Up Instructions

10

START UP AND OPERATION

Water Fill and Priming

1. Be sure the Flow Valve on discharge piping is
OPEN (lever 90° to pipe).
2. Add water to the system by removing the top lid
of the pump and filling the pump stainer basket
with water.
3. Add water until the water level in the tub is 2" to
3" from the top lip. Securely fasten the lid after
the tub is full.
4. Check the water level periodically - water can
evaporate over time. Be sure the water level in
the tub is at least half full.
Pump can draw up to 3000 watts of power during priming and start up (typical 120V 20 Amp circuit
is limited to 1800 watts maximum). Check to be sure the pump watt and power usage does not
exceed the rated capacity of the electrical outlet.
For continued, safe operation, the pump's maximum speed has been set to 2800 RPM prior
to shipment. It is recommended that the maximum speed not be changed. Do not change preset
maximum pump RPM without contacting an authorized Pentair representative.

Start Up Sequence

1. Switch ON the transformer (red light means
power is on). Be sure switch on power strip is
ON.
2. Switch the DAQ-202 "Black Box" Unit ON. The
keypad will light up on the pump.
3. Be sure to read important instructions above.
Turn the pump ON. (Press Stop/Start button on
pump keypad). Keep finger on the Stop/Start
button and look for any sign of leaking water. If
this occurs, press the Stop/Start button to turn
the pump off.
4. Look inside the kiosk and inspect flexible
connections for leaks. If leaks are found, tighten
loose connections, and resume start up.
INTELLIFLO Variable Speed Pump Demo Kiosk Operation and Set Up Instructions
®
IMPORTANT! READ BEFORE TURNING ON THE PUMP
DO NOT ADD ADDITIONAL WATER
AFTER THE INITIAL START-UP.
Water in pipes could drain downward and cause an overflow
into the water tub and cabinet.
Valve Open
5. Turn the monitor ON (Note: Turn on monitor
before turning on the computer).
6. Turn the wireless mouse ON.
7. Turn on computer. The computer should
automatically boot up into pump start up screen.
If LCD monitor screen does not display in full
screen, verify screen settings are set to 1440 x
900. (See troubleshooting on page 14 for more
information). (Note: only applies to earlier demo
units that used a laptop).
Valve Closed