Scheppach HM140L Translation Of Original Instruction Manual page 27

b) Use clamps to support the workpiece when-
ever possible. If supporting the workpiece
at least 100 mm from either side of the saw
blade. Do not use this saw to cut pieces that
c)
clamped or held against both the fence and
the table. Do not feed the workpiece into the
d) Push the saw through the workpiece. Do not
pull the saw through the workpiece. To make
a cut, raise the saw head and pull it out over
the workpiece without cutting, start the mo-
tor, press the saw head down and push the
saw through the workpiece.
e)
of cutting either in front or behind the saw
blade.
f) Do not reach behind the fence with either
hand closer than 100 mm from either side of
the saw blade, to remove wood scraps, or for
g)
workpiece is bowed or warped, clamp it with
the outside bowed face toward the fence. Al-
tween the workpiece, fence and table along
the line of the cut.
h) Do not use the saw until the table is clear of all
tools, wood scraps, etc., except for the work-
piece.
i)
www.scheppach.com /
-
-
-
-
-
-
service@scheppach.com /
j) Ensure the mitre saw is mounted or placed on
k)
bevel or mitre angle setting, make sure the ad-
workpiece and will not interfere with the blade
l) Provide adequate support such as table ex-
tensions, saw horses, etc. for a workpiece
that is wider or longer than the table top.
m) Do not use another person as a substitute for
a table extension or as additional support.
n)
saw blade.
o)
or tubing.
p) Let the blade reach full speed before contact-
ing the workpiece.
q) If the workpiece or blade becomes jammed,
parts to stop and disconnect the plug from
pack. Then work to free the jammed material.
r)
hold the saw head down and wait for the blade
s)
plete cut or when releasing the switch before
tion.
+(49)-08223-4002-99 / +(49)-08223-4002-58
-
-
-
-
-
| 27