Control Unit; Materials; Environmental Conditions; Guidance And Manufacturer's Declaration - Invacare Softform Active 2 RX User Manual

9.2 Control unit

Main Supply
Rated Input Current
Supply Fuse
Noise Level
Classification
Cycle Time
Size
Weight
Air Flow
Operating Pressure
Power
Control unit fuse
Ingress protection
* Protected from touch by fingers and objects greater than 12 millimeters. Protected against vertically falling drops
of water or condensation.

9.3 Materials

Foam
Cover
Air Cells
Glide Membrane
Control unit and mattress components do not contain natural rubber latex.

9.4 Environmental Conditions

Ambient temperature
Relative humidity
Atmospheric pressure

9.5 Guidance and manufacturer's declaration

The device is intended for use in the electromagnetic environment specified below. The customer or the user of the device
should assure that it is used in such an environment.
Electromagnetic emissions
Emission test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
1627707-D
Polyurethane Combustion Modified High Resilience Foam
Polyurethane transfer coating on weft knitted fabric
Polyurethane coated nylon
Polyurethane Film
Operation
10 °C – 35 °C
20 % – 80 %, non-condensing
70 – 106 kPa
Compliance Electromagnetic environment – guidance
Group 1 The device uses RF energy only for its internal function. Therefore, its RF
emissions are very low and are not likely to cause any interference in
nearby electronic equipment.
Class B The device is suitable for use in all establishments, including domestic
establishments and those directly connected to the public low-voltage
power supply network that supplies buildings used for domestic purposes.
Class A
Complies
220 – 240 V~, 50/60 Hz
1 A
1 A
≤ 24 dB
Class II Type BF
10 min, A/B +/- 1 min
275 mm X 155 mm X 105 mm
1.75 kg
4 l/min
60 mm Hg (8 kPa)
23 VA
T1 AL 250 V
IP21 *
Storage and Transport
-15 °C – 50 °C
10 % – 90 %, non-condensing
50 – 106 kPa
Technical Data
17