Table of Contents
Advertisement
4. With the coolant surge tank pressure cap oft', start the
5.
Then replace the pressure cap. Be sure the arrows on
engine and let it run until you can feel the upper
the pressure cap line up like this.
radiator hose getting hot. Watch out for the
engine fans.
By this time, the coolant level inside
the coolant Driver Information Center, coolant
is at the proper fill
surge tank may be lower. If the level is lower, add
level. If a CHECK COOLANT LEVEL message does
more of the proper mix to the coolant surge tank
appear, repcat Steps 1 to 3 or see your dealer.
until the level reaches about 2.5 inches (60 mm)
below the base of the filler neck.
Start the engine and allow it to warm up. If the CHECK
COOLANT LEVEL message does not appear on the
Advertisement
Table of Contents
