1. Introduction R718PA5 is a Class A device based on the LoRaWAN protocol of Netvox and is compatible with LoRaWAN protocol. R718PA5 can be connected with an NO sensor (RS485), and report the NO concentration collected by the device to the corresponding gateway. The device is compatible with LoRaWAN protocol.
Applicable to the third-party platforms: Actility/ ThingPark/ TTN/ MyDevices/ Cayenn Note: Battery life is determined by the sensor reporting frequency and other variables, please refer to http://www.netvox.com.tw/electric/electric_calc.html On this website, users can find battery lifetime for varied models at different configurations.
4. Set Up Instruction On/Off Power On DC12V adapter DC12V power supply, the green indicator flashing once means Turn On turn on successfully. Turn Off Press and hold the function key for 5 seconds, and the green (Restore to factory setting) indicator flashes 20 times Power Off Remove DC12V adapter...
(5Bytes, Fixed 0x00) portRsp (2bytes Unit: s) (2bytes Unit: s) (1) Configure R718PA5 device parameter MaxTime = 1min (The MinTime configuration is useless, but it needs to be set greater than 0 because of the software limitation.) Downlink: 0157000A003C0000000000 Device Return:...
6. Installation 2. R718PA5 regularly reports data that is 1. R718PA5 has the built-in magnet (as the figure NO2 concentration according to MaxTime. below) which can be attached to the surface of an The default Max Time is 3 min.
7. Important Maintenance Instruction Kindly pay attention to the following in order to achieve the best maintenance of the product: • Keep the equipment dry. Rain, moisture and various liquids or water may contain minerals that can corrode electronic circuits. In case the device is wet, please dry it completely. •...