Table of Contents
Advertisement
2
Safety information
2.1 Symbols used
This note comprises instructions needed to follow directions, specifications,
proper working procedure and to avoid data loss, damage or destruction of
the instrument.
This note signifies a warning about dangers to life and limb if the apparatus
is handled improperly. Observe these notes and be particularly careful in
these cases. Also inform other users on all safety notes. Besides the notes
in this instruction manual the generally applicable safety instructions and
regulations for prevention of accidents must be observed.
2.2 Safety notes and hints
It is strictly forbidden to open the housing of the Proceq ZAA 2300. If
not observed, all the guarantee and liability claims to Proceq SA will be void.
Place the device on a solid, even surface before operation and ensure that
the separator (power socket) is accessible and that the instrument can be
separated from the power supply at any time.
Never touch any moving parts under power.
Only connect the ZAAA 2300 to alternating current of a voltage of 100 – 240
V at 50 to 60 Hz. The voltage must correspond to the information given on
the identification plate of the apparatus. The device may only be connected
to sockets with a protective earth conductor.
Never use a damaged power cable. Only use power cables with protective
earth conductor. Removable power cables must not be replaced by an
insufficiently rated power cable. In the application "heatable application"
together with heating plates, only power cables with correspondingly
increased temperature resistance (≥155 ° C) may be used as supply cable.
Only use the power cable provided by the manufacturer.
Never touch the hot plate, always wait until the heating plate has cooled.
Only coating materials or products with a flash point >250 °C can be applied.
Materials with a combustion point <250 °C must not get in touch with the
heating plate.
Depending on the coating material used, the test may only be carried out in
a ventilated environment.
Heating of substances can lead to risk of explosion, implosion or the release
of toxic or flammable gases. If heating of a product can lead to the release of
hazardous substances, it is necessary to use an appropriate extraction
system.
During operation the distance to walls and other objects must be at least 10
cm.
Always unplug the power cable before assembling and/or converting the
unit.
Page 6
Advertisement
Table of Contents
