Proceq ZAA 2300 Instruction Manual page 19

Hint: Place a piece of paper at the end of your substrate to absorb any excess
coating material.
•
Set the desired drawing speed in mm/s with the SPEED button.
•
Apply the desired quantity of coating material on the substrate in front of the
applicator rod.
•
Start the drawing procedure by turning the "FWD-STOP-REV button (13) to
the FWD (forward) position.
The drawing unit (22) now moves forwards and draws a uniform film on the
substrate. Let the drawing unit (22) move to the end stop position (2) where it will
stop automatically.
•
Lift the weight (7) and hinge it into the top position.
•
Remove and clean the applicator rod.
•
Move the drawing unit (22) back to the initial position by turning the FWD-
STOP-REV button (13) to the REV (backwards) position.
•
Remove your substrate. If the device is not needed anymore switch it off with
the main switch (16).
Should the wire bar or profile rod rotate during application, then use the
optional fixing unit for profile rods and wire-bar applicators (see-chapter 6.2.1
on page 20).
Page 19
.