Proceq ZAA 2300 Instruction Manual page 21

•
Lock the end stop (2) by refastening the screw.
•
Move the drawing unit (22) back to the starting position and place the
applicator in front of the weight (7) again.
Refer to the separate instruction manuals of the applicators you are using (e.g.
ZUA 2000) for any applicator specific considerations.
Hint: Place a piece of paper at the end of the substrate to absorb any excess
coating material.
•
Set the desired drawing speed in mm/s with the SPEED button (14).
•
Apply the desired quantity of coating material on the substrate in front of the
application blade.
•
Start the application procedure by turning the FWD-STOP-REV button (13) to
the FWD (forward) position.
•
Move the drawing unit (22) back to the starting position by turning the FWD-
STOP-REV button (13) to the REV (backward) position.
•
Remove and clean the gap applicator.
•
Remove your substrate. If the unit is not needed anymore, switch it off with the
main switch (16).
Page 21