Table of Contents
Advertisement
8
Maintenance and cleaning
8.1 Maintenance and cleaning work that can be carried out by the user
Only the following maintenance and cleaning work shall be carried out by the user:
•
Outer cleaning of the apparatus (see chapter 8.2 on page 24).
•
Periodical lubrication of the guide rods (see chapter 8.3 on page 25).
•
Replacing of the fuse (see chapter 8.4 on page 25.
•
Inspection (see chapter 8.5 on page 26).
All other maintenance and repair work shall only be carried out by Proceq SA
or your authorised Proceq agent otherwise all guarantee and liability claims
are void.
8.2 Cleaning
In order to ensure a perfect function, the film applicator should be kept as clean as
possible. Remove eventual stains of coating materials or adhesives immediately
before they can dry. Later they can often only be removed with difficulty.
For cleaning of the apparatus use commercially available cleaning agents such as
cleaning agent for glass, benzine, acetone. Do not use strong acids or alkaline
liquids! For cleaning of the printing blanket use only cleaning agents which do not
affect the printing blanket. Unsuitable for this purpose are solvents containing
ketone such as acetone, or nitro-cellulose diluents.
The edge of the printing blanket of the glass plate must not get wet.
Before cleaning the Proceq ZAA 2300, always switch off the apparatus and
unplug it. Never immerse the apparatus in water or other liquids: Danger of
short circuit.
Never touch the hot plate, always wait until the heating plate has cooled.
While cleaning, take care that no cleaning liquid penetrates the interior of the
apparatus. The function of electrical or mechanical components could be
impaired.
If the device has to be disinfected, do not use disinfectants that contain
sodium hydroxide.
Page 24
Advertisement
Table of Contents
